Datasheet
SPECIFICATIONS
CUSTOMER MODEL NO. / TITLE
OPTICAL RECEIVING JACK
6. Environmental test
6A) Life test
The life test shall consist of 150 cycles of insertion and withdrawal with gauge plug covered with a
thin coat of grease in order to prevent from heating or wearing, at a rate of 20 to 30 cycles per
minute under no load. At the conclusion of this test, the jack shall comply with Paragraphs 3 & 4,
and be in operating condition.
6B) Humidity test
The jack shall be subjected to temperature of 40±2℃ and relative humidity of 90% to 95% for a
period of 96 hours. Upon completion of the exposure, dewdrops shall be blown out and removed
from the jack, after which the jack shall be conditioned at room ambient conditions for 30
minutes. At the conclusion of this test, the jack shall comply with paragraphs 3 & 4.
6C) Heat test
The jack shall be subjected to temperature of 70±2℃ for a period of 96 hours, then shall be allowed
to remain in room ambient conditions for 30 minutes. At the conclusion of this test, the jack shall
comply with Paragraph 3 & 4.
6D) Cold test
The jack shall be subjected to temperature of –40±3℃ for a period of 96 hours, then shall be
allowed to remain in room ambient conditions for 30 minutes. At the conclusion of this test, the jack
shall comply with Paragraph 3 & 4.
6E) Resistance to soldering heat test
The jack terminal shall be dipped in solder under the condition as specified below. At the
conclusion of this test, the jack shall comply with Paragraph 3 & 4, and not show remarkable
failure.
6E1. The terminal for a printed circuit board.
Temperature of solder: 260±5℃; Dip time: 5±1 seconds.
6E2. The terminal for a lead wire
Temperature of solder: 350±10℃; Dip time: 3±0.5 seconds.
6F. Temperature cycling test
The jack shall be subjected to the conditions as shown in fig as follows. And then shall be returned and
allowed to remain in room ambient condition for 30 minutes. At the conclusion of this test, the jack
shall comply with Paragraph 3 & 4.
(TEMPERATURE) ──
＞
1 Cycle
＜
──
+60
℃
-40
℃
(TIME)
0h 2h 4h 6h
W
R
T
N
CLIFF ELECTRONIC COMPONENTS LTD
A
P
V
D
SPECIFICATION NO.
FC684206R
C
H
K
D
C
H
K
D
PAGE： 10 OF 11
DATE： OCT.28.2003
REV. NAME DATE REMARK