User guide

Clickfree C6 Easy Imaging Frequently Asked Questions
Copyright © 2011 Storage Appliance Corporation. 26
To erase the backed-up content and disable password protection, select Erase all backed
up data but do not re-enable security , then click Erase .
3. Click Yes to confirm that you want to erase all backed up content.
U PDATING C LICKFREE SOFTWARE
From time to time Clickfree software is upgraded to provide new or enhanced features. You
must manually check for updates. The C6 must be connected to your computer, and the
computer must be connected to the Internet for updated software to be found and installed.
1. On the Tools window click Update . Clickfree checks for available updates.
2. If the software in your C6 and your computer is up to date, click OK on the dialog that
pops up.
If an update is available, it is downloaded and your software is updated.
While the software update is taking place, do not remove the C6 from your computer
and do not turn off or restart the computer until the update is complete.
3. When the software update is complete, you must unplug the C6 and plug it in again for
the update to take effect.
R ESETTING THE C6
Master Reset is used to remove all backed-up content from all computers that have been
backed up on your C6, and to apply factory settings.
After you perform a Master Reset you can no longer restore any previously backed-up
content, but your C6 can still be used for new backups.
If you want to remove only the content that was backed up from one computer, see
“Removing a computer” on page 24.
1. On the Tools window click Master Reset .
2. You are prompted to confirm that you want to remove all backed-up content from
Clickfree – select the check box and click Reset .
Once you have removed content from Clickfree using Master Reset there is no way to
recover any backed-up content from the C6.
Clickfree may take several minutes to erase all of the content, depending on the amount of
content backed up on the C6.