Manualshelf

User Manual

ManualsBrandsCli-mate ManualsAir TreatmentCli-Mate Air Purifier
12345678910
6 INSTALLATION AND OPERATING INSTRUCTIONS
CLEANING THE PRE-FILTER, HEPA AND ACTIVATED CARBON FILTER
It is recommended that the Pre-fi lter (the removable black layer) is
cleaned every 1-2 weeks of operation, depending on the air quality
of the room.
To clean fi lters:
1. Turn the unit off and disconnect the power.
2. OPEN THE FRONT COVER: Place both hands at the bottom
corners of the front cover and pull out.
3. REMOVE THE FILTER: Pull out the fi lter by the belt attachment.
4. Gently peel away the Pre-fi lter (black layer), which is attached
by Velcro.
5. Run a vacuum cleaner with a nozzle or brush attachment
on low power setting along the HEPA (white side), Activated
Carbon (black side), and both sides of the Pre-fi lter to pick up
the dust and various particles.
6. Re-attach the Pre-fi lter layer and place the fi lter back into the
air purifi er.
Note: When placing the fi lter back into the air purifi er, ensure that
the fi lter belts and Pre-fi lter is facing outwards.
7. Reattach the front cover.
REPLACING THE FILTER
When the lifespan of the 3-layer fi lter reaches its end, the icon
light located under the “REPLACE FILTER” will fl ash, indicating that
it needs to be changed. Discard the old fi lter and replace with a
new one. It is not reusable.
The lifespan and duration of the fi lter depends on the air quality
and surrounding environment. The higher the level of pollutants,
the shorter the fi lter lifespan. It is advisable to change the fi lter at
least every 6 months of unit operation.
Cli~Mate Replacement Filter Product Code: CLI-AP35-RF
HOW TO REPLACE THE FILTER
1. Turn the unit off and disconnect the power.
2. OPEN THE FRONT COVER: Place both hands at the bottom
corners of the front cover and pull out.
3. REMOVE THE FILTER: Pull out the fi lter by the belt attachment
and discard.
4. INSTALL NEW FILTER: Replace with the new fi lter.
Ensure that the fi lter belts and Pre-fi lter is facing outwards.
5. Reattach the front cover.
6. Hold down the AUTO
button for 5 seconds to
reset the fi lter timer.