Ultrasonic Humidification System Instruction Book – CLI-AH300 by
Contents 2 Cli-Mate Recommends Safety First 6 Components 7 Functions 11 Care & Cleaning 12 Troubleshooting CLI-MATE RECOMMENDS SAFETY FIRST At Cli-Mate we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions.
• Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • Children should be supervised to ensure that they do not play with the appliance. • Do not use appliance for other than intended use.
• Keep the unit away from fire, flammable gas, combustible products or vapours, and corrosive substances. • Do not operate the unit without filters. • When transporting the air purifier, always hold the handles on the side of the unit. • To protect against fire, electric shock and personal injury, do not immerse cord, plugs, or appliance in water or other liquid. • Do not place on or near a hot gas, electric burner or heating appliance.
• Children should be supervised to ensure they do not play with the appliance. • It is recommended to regularly inspect the appliance. Do not use the appliance if power cord, power plug or appliance becomes damaged in anyway. Return the entire appliance to the nearest authorised Cli-Mate Service Centre for examination and/ or repair. • Any maintenance other than cleaning should be performed at an authorised Cli-Mate Service Centre. • This appliance is recommended for household use only.
Components A B C D E F G H I J K L M A. B. C. D. E. F. G. 6 Mist Nozzle Carry Handle Water Tank Water Inlet Conditioning Cartridge Water Tank Cover Control Panel H. I. J. K. L. M.
Functions LCD DISPLAY PANEL REMOTE CONTROL A. B. C. D. E. F. G. H. Mist Level Timer (hour/s) Current Humidity Level (%) Humidity Level Set Refill Water Anion Function On/Off Current Room Temperature (Celsius) A. B. C. D. E. B D A C E Power On/Off Mist Level Humidity Level Anion Timer A B H C D G F E WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the oesophagus.
Functions Fig. 1a Fig. 1b USING THE REMOTE CONTROL Before using the remote control, remove the battery isolating slip by pulling the slip away from the remote control. The remote control buttons operate in the same way as those on the tower heater control panel. Your remote control includes 1 x CR2032 3V Lithium battery.
OPERATION INSTRUCTIONS 1. Locate a flat stable location and plug the power cord into the appropriate electrical outlet. 2. Take off the mist nozzle and remove the water tank from the base and turn water tank upside down. 3. Unscrew the water tank cover and fill water tank with clean water. Important: Temperature of the water should not exceed 40°C. 4. Replace the water tank cover and position the water tank back onto the base. 5. Place the mist nozzle back into place. 6.
SCENT PAD The unit includes a scent pad, which can be used to send light aroma into the air. To use pull out the scent tray located near the base on the right hand side of the unit (see Fig 2.) Add a few drops of aroma essential/oils on the pad. Place the pad back into the tray and close. NOTE Aroma/essential oils not included. Fig.
Care & Cleaning CAUTION: Before carrying out cleaning or maintenance of the product, always turn off and unplug the cord from the power socket. • Do not rinse the unit or immerse the unit in water. • Do not use detergent to clean any watercontaining parts of the humidifier. • Do not use abrasive cleaners or brushes to clean. • Clean the surface of the device with a soft cloth.
Troubleshooting PROBLEM POSSIBLE CAUSES EASY SOLUTION No Power. • • Little or no mist is produced. • • • Abnormal noise. • • White dust accumulation. 12 • • Unit is not plugged into wall socket. No water in water tank. Scale build up on transducer. Water is too dirty or kept for too long in the tank. Very low water levels in water tank. Unit is on an uneven surface. Hard water used. Filter needs cleaning. • • • • • • • Check connection to wall socket. Fill water tank.
Notes 13
Notes 14
Notes 15
Breville Customer Service Centre Australian Customers New Zealand Customers Phone: 1300 139 798 Phone: 0800 273 845 Web: Web: www.breville.com.au www.breville.co.nz Breville is a registered trademark of Breville Pty. Ltd. A.B.N. 98 000 092 928. Copyright Breville Pty. Ltd. 2018. Due to continued product improvement, the products illustrated/photographed in this brochure may vary slightly from the actual product.
