Service manual

Disassembly
Removing the Hard Disk from the Secondary HDD Bay 2 - 23
2.Disassembly
3. Firmly insert the HDD cable into the hard disk assembly in the direction of the arrow as indicated
below (Figure 18c).
4. Insert the HDD assembly into the bay by pushing it straight down (Figure 18d). *Do not insert the assembly at
an angle.
5. Firmly connect cable to the mainboard and then secure the assembly with screws - (Figure 18d).
Removing the Hard Disk from the Secondary HDD Bay
7
8
9
7
10
13
9
11
10
12
c.
d.
7
8
7
7
13
Figure 18
Inserting the
Primary Hard
Disk(s) (cont’d.)
c. Firmly insert the HDD
cable into the hard
disk assembly.
d. Insert the HDD as-
sembly into the bay
by pushing it straight
down. Firmly connect
the cable and then se-
cure the assembly
with screws.

8. Hard Disk Assembly
9. Hard Disk Cable
•4 Screws