Service manual

Disassembly
2 - 8 Removing the System Memory in Socket Two
2.Disassembly
Removing the System Memory in Socket Two
1. Remove the battery (page 2 - 6) and turn the computer over.
2. Remove screws & (Figure 2 - 3a).
3. Lift the memory socket cover off the computer (Figure 2 - 3b).
4. Locate the memory socket and carefully pull latches and (Figure 2 - 5c) on the memory socket in the direc-
tion indicated by the arrows in Figure 2 - 5c.
5. The module (Figure 2 - 5d) will pop-up, and you can remove it.
6. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
Figure 2 - 3
System Memory
(Socket 2)
Removal
Sequence
a. Remove screws 1 &
2.
b. Remove the cover.
c. Pull the latches in
the direction indicat-
ed.
d. Release the mod-
ule.
1 2
3
4 5
6
a.
b.
2
1
3
3
5
4
6
d.c.

3. Socket Cover
6. Memory Module
•2 Screws