Service manual

2 – 27

D ISASSEMBLY

2. DISASSEMBLY

HDD Removal

HARD DISK DRIVE REMOVAL

The HDD is housed in the Base Assembly.

1. Place the LCD PC with its LCD panel facing up and remove Screw A. (Only the LP200T has this screw.)

2. Remove Screw B.

EMOVING SCREWS A & B

IG. 2-26

3. Pull the HDD Cartridge out from its bay until the HDD’s connectors are exposed.

4. Separate the HDD cartridge from the rest of the system by disconnecting the HDD’s IDE Cable (A) and Power Cable (B).

(Both of these cables are a tight fit.)

ULLING THE HDD CAR-

TRIDGE OUT AND DISCONNECT-

ING THE IDE & POWER

CABLES

FIG. 2-27