Service manual

2 – 26

D ISASSEMBLY

2. DISASSEMBLY

USB BOARD REMOVAL

The USB Board is in the Base Assembly. Only the LP200C has this feature.

Part A

Remove the Base Assembly. (pages 2-21 & 2-22)

Remove the HDD Cartridge. (Step 1 of Part B of the Power Supply Removal Procedure, page 2-23)

Remove the Swivel Stand. (Step 2 of Part B of the Power Supply Removal Procedure, page 2-24)

Remove the Top Cover of the Base Assembly (Step 3 of Part B of the Power Supply Removal Procedure, page 2-24)

Part B

Separate the USB Board from the rest of the Base Assembly.

A. Disconnect the USB Cable from Connector CN1 on the USB Board.

B. Remove Screw A which secures the board to the Bottom Cover of the Base Assembly.

USB Board Removal

REMOVING THE USB BOARD

FIG. 2-25

USB Board

CN1