Service manual

2 – 23

D ISASSEMBLY

2. DISASSEMBLY

POWER SUPPLY REMOVAL

The Power Supply is in the Base Assembly.

Part A

Remove the Base Assembly. (pages 2-21 & 2-22)

Part B

1. Remove the HDD Cartridge.

A. Turn the Base Assembly upside down and remove Screw A. (Only the LP200T has this screw.)

B. Remove Screw B and pull the HDD Cartridge out from its bay until the HDD’s connectors are exposed.

C. Disconnect the following cables.

(C1) The Power Supply to HDD (power cable).

(C2) The System Board to HDD (HDD signal cable).

Power Supply Removal

REMOVING THE HDD

ARTRIDGE

FIG. 2-21

HDD Cartridge