Service manual

2 – 7

D ISASSEMBLY

2. DISASSEMBLY

MEMORY MODULE REMOVAL

REMOVING DIMMS

Part A

Remove the Back Cover. (page 2-4)

Part B

Release the levers on the two ends of

the DIMM slot. As you do so, the mod-

ule will rise slightly and remove the

seated DIMM, one at a time.

EMOVING THE DIMMS

FIG. 2-5

INSTALLING DIMMS

1. Insert a DIMM in either slot at about a 20

angle. Grooves on the sides of the module

allow you to insert it only one way. Make sure

it is seated as far into the slot as it will go.

DO NOT FORCE IT. The module should fit in

without much pressure. If there is a lot of

resistance, check to make sure the DIMM is

properly seated.

2. Click in the slot levers to secure the module.

3. Reinstall the back cover.

NSTALLING THE DIMMS

FIG. 2-6

FMemory Upgrade Note:

• If you have changed the memory configuration, run SCU so the new total can be registered in the CMOS.

• If you have increased memory, check to see if you need to recreate the Hibernate-specific file if the system

runs Windows 98 SE with Hibernate support enabled. (Refer to

Chapter 3, Advanced Controls

Chapter 5,

Drivers & Utilities

of the CD-based complete

User’s Manual

for details.)

DIMM Removal & Installation