Operating instructions
Table Of Contents
- User's Manual
- Notice
- Contents
- Chapter 1: Introduction
- Chapter 2: Using The Computer
- Chapter 3: Advanced Controls
- Overview
- Advanced Video Controls
- Display Devices
- Display Options
- Enabling Other Displays
- Power Management Features
- Enabling Power Management/Options
- Chapter 4: Drivers & Utilities
- Chapter 5: BIOS Utilities
- Chapter 6: Upgrading The Computer
- Chapter 7: Troubleshooting
- Appendix A. Specifications
- Glossary
Upgrading The Computer
6 - 10 System Memory Upgrade
6
9. Insert the new module. The module will only fit one way as
defined by the pin alignment.
10. Make sure the module is seated as far into the slot as it will go
(DO NOT FORCE IT). The latches will click into place on the
sides of the module. Make sure they are secure.
11. Reverse the procedures to put the computer back together, and
do not forget all the screws. When you restart the computer the
new memory configuration should be registered.
12. If the system doesn’t properly detect the new memory, and you
are sure they are properly “seated”, you may need to run the
setup utility.
Figure 6 - 8
RAM Module
Insertion