Service manual

Disassembly
2 - 18 Removing and Installing the Processor
2.Disassembly
Processor Installation Procedure
1. Insert the CPU , pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE IT!).
2. Move the latch towards the lock symbol and bracket fully in the direction indicated to lock the CPU.
3. Apply the thermal grease to the top of the CPU as shown (Figure 13b).
4. Insert the heat sink
(make sure not to trap or catch the plastic VGA heat sink tab under the CPU heat
sink when inserting it ) note as indicated in Figure 13c.
5. Tighten the CPU heat sink screws
, , , , , & (Figure 13d) and connect the CPU fan cables - .
6. Insert CPU fan and tighten the screws - (Figure 13e).
7. Replace the component bay cover and tighten the screws (page 2 - 16).
A
B
C
D
E
F
1
2
3
4
5
6
7
8
G
9
11
c.
b.
B
A
a.
E
C
4
1
3
2
6
5
7
8
e.
d.
9
10
11
F
G
Note: make sure not to trap or
catch the plastic heat sink tab
while
removing or tighting the screw
.
4
D
Figure 13
Processor
Installation
a. Insert the CPU.
b. Move the latch to-
wards the lock symbol
and bracket fully
in the direction indicated
to lock the CPU. Apply
therrmal grease.
c. Insert the heat sink.
d. Tighten the screws and
connect the CPU fan ca-
bles.
e. Tighten the screws.
B
C

A. CPU
E. Heat Sink
G. Heat Sink Fan
•9 Screws