Service manual

Disassembly
2 - 8 Removing the Hard Disk Drive
2.Disassembly
4. Remove screws - and pull the tab to disconnect the connector from hard disk assembly.
5. Carefully lift the hard disk assembly using two hands at points - .
6. Lift the hard disk assembly out of the computer.
7. Separate the hard disk board connector from the hard disk assembly.
8. Remove screws - (depending on how many hard disks you have installed in the assembly).
9. Separate the hard disk(s) and hard disk mylar
from the case .
10. Reverse the process to install a new hard disk(s) and make sure to connect cable before screwing in screws
- (Figure c).
Figure 4
HDD Assembly
Removal (cont’d.)
c. Remove the screws.
d. Lift the hard disk assem-
bly using two hands at
points - .
e. Lift the hard disk assem-
bly up out off the compu-
ter.
f. Remove the HDD(s) from
the connector
g. Remove the screws and
separate the HDD(s)
from case.
9
10

11 Hard Disk Assembly
12 Hard Disk Board
Connector
25. Hard Disks
26. Hard Disk Mylar
27. Hard Disk Case
• 16 Screws
4
7
8
9
10
11
12
12
23
25
26
27
8
4
7
4 5
6
7
d.
c.
8
e.
11
10
9
f.
15
13
21
16
22
17
14
12
18
19
23
24
20
25
26
25
27
g.
11