Service manual

"

!
4
$
%
&
Troubleshooting
4 – 28
suspend & battery status
SUSPEND FUNCTION FAILURE
Pressing the suspend key combination will enable the system to enter Suspend mode after few seconds. The power
status LED will not light if the system is in Save to Disk mode. If the system can’t enter Suspend mode it may be
because the Power Savings in your BIOS setup are not set properly. If any of the current settings are wrong, change
them.
CHARGE LED FAILURE
If the Charge LED doesn’t turn green after the battery pack has been recharged for about 3 hours with power off or
6 hours with power on, there are several possible explanations:
• The battery pack is malfunctioning.
• The AC/DC adapter is malfunctioning.
• The Charge LED is malfunctioning.
Replace the battery pack and recharge the new one. If the Charge LED still does not turn green after the necessary
recharge time, check or replace the AC/DC adapter. If the problem persists with the new AC/DC adapter, check the
Charge LED or send the notebook to the nearest service center for repair.