Service manual

3 – 22

Disassembly

HDD

Jumper Warning

Some (usually older) HDDs

have a small jumper switch.

It must be set to “master” or

the system may not correctly

recognize the drive. Check

your drive’s documentation.

ASSEMBLING THE HDD MODULE

When you’re ready to install a new hard disk,

1. Hold the HDD by its edges and orient it so that the connector pins side faces the open end of the

bracket.

2. Settle the bracket around the HDD. In the correct position, the holes in the bracket’s sides line up

with the module’s screw holes. (To fit tnto the HDD bay, the HDD’s sides must not extend outside the

bracket.)

3. Fasten the four (4) bracket screws (A ~ D) removed in step 1 in the section, “Taking it Apart”,

described on page 3-21.

HDD MODULE ASSEMBLY

FIG. 3 – 13

1. bracket

2. HDD (electronics face-down)

3. connector

Refer to the text for the accompa-

nying instructions.