Use and Care Manual

ANCHORING INSTRUCTIONS

4 ANCHORING SCREWS

ANCHORING PARTS

POWER DRILL (NOT INCLUDED) , MASONRY DRILL BIT,

AND PHILLIPS DRILL BIT (BITS INCLUDED)

TOOLS NEEDED

STEP 1-DRILLING ANCHORING HOLES

Before you begin: Place the LockBox in desired location. The back of the

LockBox needs to be at least 2 inches away from any wall or other surface

before you begin to anchor. This will allow the lid to open properly without

interference.

-Using your power drill with the masonry bit (included), insert the bit into the

open hole in one of the four bottom corners and drill into the ground. (Please

note: this drill bit will work on wood or concrete).

Repeat drilling in all four corners.