Use and Care Manual

SET UP YOUR PERSONAL CODE
1. Press the “#” to activate the screen
(NOTE: lock won’t beep or light up)
2. Press the “#” button two additional times
3. Enter the preset factory four digit passcode (0000)
4. Press the “#” button twice again
5. Now enter your desired four digit passcode
6. Press the “#” button twice-you should hear two beeps
7. Once the lock beeps twice, your personal code is set
To open the box, simply enter your four digit code and
then press the “#” button. The lid will pop open.
KEYPAD INSTRUCTIONS
1
4
7
2
5
8
0
3
6
9
*
#
11
NOTE: If the light on the LockBox screen turns off while setting up your code you
will need to start over.