User`s manual

www.brothermax.com
15
10 Probe Guard:
•Youcanopenorclosetheprobeguardbyflippingitupordown.
•AlwayskeeptheprobeguardclosedinAmbienttemperature
modeoraftermeasuringearorforeheadtemperatureto
preventabuildupof dirtanddustontheprobe,whichmay
giveaninaccuratetemperaturereading.
11 Switching Display Direction on Screen:
•InAmbienttemperaturemode,thescreenautomaticallyflips
upordown-dependingonwhichwaythethermometerisbeing
held(byhandoronthestand)-soitcanalwaysbereadinthe
correctorientation.Ashortbeepwillsoundaftereachtimethe
screendisplayflipsupordown.
•Youwillalsohearasoft‘ticking’soundwhenyouturnthe
thermometerupsidedown.Thisisnotafault!Itisthe‘tilt
switch’thatenablesthescreentoalwaysknowwhichwayupit
shouldbe,doingsowithouttheneedformercury.
How To Use the Accessories
1 Stand:
•TheStandisprovidedsothethermometercanbeconveniently
andsafelypositionedwhilstmeasuringAmbienttemperature
and/orsoyoualwaysknowwhereitis.
•OnceontheStand,thethermometerisfreetorotatethrough
180°,allowingittobepositionedonhorizontalorvertical
surfaces,suchas:
•onatable(Fig.9) •underashelf (Fig.10)
•onashelf (Fig.9) •onawall(Fig.11)
•Thescreenwillautomaticallydisplaytherightwayinallpositions.
•ToplacethethermometerontotheStand,gentlypullthetwo
armsontheStandapartandinsertthethermometerin-between
thearms.
•Toremoveit,useonehandtogentlypullthetwoarmsopen
and,atthesametime,holdandliftoutthethermometerwith
yourotherhand.
•Anadhesivepadissuppliedalreadyaffixedtothebaseof the
Standtoeasilymountittoawallorunderashelf.Todoso,first
removethepaperfromtheadhesivepadplacedunderneath
theStand,thenpositiontheStandintherequiredlocationand
finallyaddthethermometer(asabove).
Note: When affixing the Stand to a wall, be careful to ensure that it is
straight to ensure that the thermometer does not appear wonky when
placed in the Stand.
You do not need to remove the paper from the adhesive pad if simply
freestanding the Stand on a shelf or table.
2 Carry Case:
•TheCarryCase(Fig.12seepage16)isprovidedtoconveniently
protectthethermometerwhennotbeingusedoristaken
outside.
•TheProbeGuardshouldbeclosedandthermometerswitched
OFFbeforeplacingthethermometer
insidetheCarryCase.
Fig. 9 Fig. 10 Fig. 11