Operating instructions

MARINE LOCK
Your unit is equipped with a marine
lock to prevent accidental tilting.
The following procedure should be
used to tilt the kettle.
1. Grasp the tilt handle.
2. Hold the latch down to unlock tilting mechanism.
3. Pull the handle to tilt kettle.
4. To lock, return the kettle to its upright position and
push handle back.
NOTE: Inspect lock daily to ensure it is free moving
and does not bind or stick. Clean lock if necessary
(see Cleaning Instructions below for details).
CARE AND CLEANING
Cooking equipment must be cleaned regularly to
maintain its fast, efficient cooking performance and
to ensure its continued safe, reliable operation. The
best time to clean is shortly after each use (allow
unit to cool to a safe temperature).
WARNINGS
➩ Do not use detergents or cleansers
that are chloride based or contain
quaternary salt.
➩ Do not use a metal bristle brush or
scraper.
➩ Steel wool should never be used
for cleaning the stainless steel.
➩ Unit should never be cleaned with
a high pressure spray hose.
➩
Do not leave water sitting in unit
when not in use.
Stagnant
Water
High Pressure
Spray Hose
Steel Pads
Wire Brush &
Scrapers
Chloride Cleaners
CLEANING INSTRUCTIONS
CAUTION
SURFACES MAY
BE EXTREMELY HOT!
CLEANING INSTRUCTIONS
1. Turn unit off.
2. Remove drain screen (if applicable). Thoroughly wash and
rinse the screen either in a sink or a dishwasher.
3. Prepare a warm water and mild detergent solution in the
unit.
4. Remove food soil using a nylon brush.
5. Loosen food which is stuck by allowing it to soak at a low
temperature setting.
6. Drain unit.
7. Rinse interior thoroughly.
8. If the unit is equipped with a
TTaannggeenntt DDrraaww--OOffff VVaallvvee
,
clean as follows:
a) Disassemble the draw-off valve first by turning the
valve knob counter-clockwise, then turning the large
hex nut counter-clockwise until the valve stem is free
of the valve body.
b) In a sink, wash and rinse the inside of the valve body
using a nylon brush.
c)
Use a nylon brush to clean tangent draw-off tube.
d) Rinse with fresh water.
e) Reassemble the draw-off valve by reversing the
procedure for disassembly. The valve's hex nut should
be hand tight only.
9. If the unit is equipped with a
BBuutttteerrffllyy VVaallvvee
, clean as
follows:
a) Place valve in open position.
b) Wash using a warm water and mild detergent solution.
c) Remove food deposits using a nylon brush.
d) Rinse with fresh water.
e) Leave valve open when unit is not in use.
10 . Using mild soapy water and a damp sponge, wash the
exterior, rinse, and dry.
NOTES
➩ For more difficult cleaning applications one of the following
can be used: alcohol, baking soda, vinegar, or a solution of
ammonia in water.
➩ Leave the cover off when the kettle is not in use.
➩
For more detailed instructions refer to the Nafem Stainless Steel
Equipment Care and Cleaning manual (supplied with unit
).