Owner`s manual

17. After both steps have run, the second signal tone sounds.
18. Clean thoroughly behind the fan guard. Clean the fan guard in a sink or dishwasher.
Remove the fan guard. See Figure 9-1.
a. Push the fan guard lock in. Do NOT use the core temperature sensor (probe).
b. Lift up on the bottom of the fan guard while pushing in on the fan guard lock.
c. Pull the bottom of the fan guard towards you and remove it.
19. Remove the oven racks operating positions and pla
ce them in the bottom of the oven chamber.
20.
Run MINI mode with Crisp ‘n’ Tasty at level 3 (High) at 212°F for 10 minutes.
21. Turn OFF the MINI.
22. IMPORTANT: Rinse the oven chamber, accessories, and behind the fan guard thoroughly
with the hand shower (or similar sprayer).
23. Repeat “Cleaning” using CONVOCare in place of CONVOClean including Step 22, rinsing the
oven chamber, accessories, and behind the fan guard thoroughly with the hand shower
(or
similar
sprayer).
24. After cleaning, replace the oven racks and fan guard.
Replace the fan guard. See Figure 9-1.
a. Insert the fan guard top edge rst into the oven chamber.
b. Place the bottom edge on the support pins.
c. Turn the fan guard lock back to its locked position. (It will click.)
25. In the case of severe staining or soiling, repeat the cleaning process.
26. After use or after cleaning, leave the MINI door open.
C. Fully-Automatic Cleaning of the Oven Chamber
NOTE: Do NOT press the Start/Stop key while using the Fully-automatic Cleaning process. This
stops the cleaning process.
Check that the following requirements have been met:
 No food has been left in the oven.
 For 6.102in1 and 10.10, make sure the two drawers are lled correctly and contain enough cleaner.
 For the 3.10 or 6.10, make sure the cleaning uid containers are connected correctly to the unit and
that the containers contain en
ough cleaning uid.
 Yo
u are already conversant with the operating steps..
1. Turn the armature nozzle on the top of the over through one complete turn to ensure that it moves
freely.
2. Remove the larger items of burnt food residues from the oven.
3. Close the appliance door
4. Select the functions menu:
5. Use the selector switch to choose the "fully automatic cleaning" icon.
6. Press the "Functions menu" button to conrm and verify that the Conrm menu appears in the display..
7. Use the tilt selector switch to choose "YES".
8. Press the "Functions menu" button to conrm that A selection menu appears in the display.
9. Use the tilt selector switch to choose the soiling level.
a. Q = quick clean
b. 1 = light soiling
c. 2 = normal soiling