Owner's manual

U LTRA S ERIES S TATIONARY S HAFT T RANSDUCER MAN-70251 R EV . AA
P AGE 8 OF 18
2 S PECIFICATIONS
Item: Specification:
Transducer Weight
1T 2T 3T
2.9 lbs.
1.32 kg.
4.0 lb.
1.81 kg
5.0 lb.
2.27 kg
Weight + Mounting Kit
1T 2T 3T
Flange 3.9 lbs.
1.77 kg.
5.6 lbs.
2.54 kg
6.6 lbs.
2.99 kg
Bearing 3.3 lbs.
1.50 kg.
4.5 lbs.
2.04 kg.
5.5 lbs.
2.49 kg.
Pillow Block 5.8 lbs
2.63 kg.
8.2 lbs.
3.72 kg.
9.2 lbs.
4.17 kg.
Material
Strain Sensing beam - heat treated 4140 alloy steel
Body - 1117 Low Carbon steel
Finish Material Corrosion resistant Zinc plated with clear Chromate
Bridge Resistance 135-147 Ohms @ 20
o
C
Gage Type Semi-conductor strain gage, gage factor equals 95 (nominal)
Connector Type M12 Quick-disconnect, 4 conductor, DC keyed
Excitation Voltage 5.6 VDC or VAC (RMS) maximum
(Excess voltage can cause permanent damage)
Nominal Output Signal at Rated
MWF
+/- 350 mV per Transducer (with 5 VDC or VAC rms excitation
voltage)
Output Impedance Approximately 64 Ohms per Bridge leg
Non-destructive Overload 150% MWF
Ultimate Overload 300% MWF (typ)
Maximum Voltage, Gage to
Beam or Base (Ground)
50 Volts peak
Operating Temperature Range 0
o
F to +200
o
F
Alignment +/- 1 degrees angular displacement
Accommodation of shaft
expansion/contraction
+/- 0.04” (+/ - 1mm) per transducer