Manual

ULTRA SERIES CANTILEVER TRANSDUCER MAN-70252 REV. AA
PAGE 8 OF 18
2 SPECIFICATIONS
Item: Specification:
Transducer Weight
1T ALUM 1T STEEL 2T STEEL
1.9 lbs.
0.86 kg.
2.7 lb.
1.23 kg
3.7 lb.
1.68 kg
Weight + Mounting Kit
1T ALUM 1T STEEL 2T STEEL
Flange
2.9 lbs.
1.32 kg.
3.7 lbs.
1.68 kg
5.3 lbs.
2.41 kg
Bearing
2.3 lbs.
1.05 kg.
3.1 lbs.
1.41 kg.
4.2 lbs.
1.91 kg.
Pillow Block
4.8 lbs
2.18 kg.
5.6 lbs.
2.54 kg.
7.9 lbs.
3.59 kg.
Material
Strain Sensing beam - heat treated 4140 alloy steel
or 2024 T351 Aluminum
Body - 1117 Low Carbon steel
Finish Material Corrosion resistant Zinc plated with clear Chromate
Bridge Resistance
Steel Transducer: 135-147 Ohms @ 20
o
C
Aluminum Transducer: 122-134 Ohms @ 20
o
Gage Type Semi-conductor strain gage, gage factor equals 95 (nominal)
Connector Type M12 Quick-disconnect, 4 conductor, DC keyed
Excitation Voltage 5.6 VDC or VAC (RMS) maximum
(Excess voltage can cause permanent damage)
Nominal Output Signal at Rated
MWF
+/- 350 mV per Transducer (with 5 VDC or VAC rms excitation
voltage)
Output Impedance Steel Transducer: Approximately 64 Ohms per Bridge leg
Aluminum Transducer: Approximately 60 Ohms per Bridge leg
Non-destructive Overload 150% MWF
Ultimate Overload 300% MWF (typ)
Maximum Voltage, Gage to
Beam or Base (Ground)
50 Volts peak
Angular Deflection 0.01 inches Max. as measured at the far end of the sensing roll
with maximum load present.
Operating Temperature Range 0
o
F to +200
o
F