Owner manual

MAN-70445-0 REV AA ULTRA SERIES ISC CANTILEVER TRANSDUCER TECHNICAL MANUAL
3.2 SOFTWARE SCALING
Figure 8 Software Scaling
Here is a simple example of software scaling
Command Description
Sample (digitize) CLT_CH and store
; Store digitized Cantilever CH.
ADD CLT CH_OFSET to CLT_CH parameter
; Cantilever CH_OFSET is the zero correction
constant.
Multiply offset corrected CLT CH parameter by CLT
CHGAIN
; This is the composite tension feedback
Note that sometimes, over-sampling and filtering can be used to generate a robust tension feedback
parameter despite brief disturbances (either mechanical or electrical).
13