Installation Instructions

3 Check before installation

Material 100% PMMA

Drain connection DN 50

(B) height of the bathtub in mm 625 - 645

Water drainage and supply

Connection of the water supply and water drainage must be carried out in accordance with the

applicable directives DIN 1988 / EN1717 and local regulations. After placing the bathtub, the

installer must check the leaktightness of the bath.

Check before mounting:

• Pay attention to the door width in the room where the bath is to be installed: is there

enough witdth for bath to be carried into the room?

• The bath may not be installed outdoors.

• The bath must be mounted on a floor suited for wet rooms.

• The floor must be strong enough to carry at least 550 kg / m². The floor must be level

and flat.

• Due to the design of the bath, a drain must be available in the floor. A drain in the wall

is not possible.

• The drain connection must be carried out in accordance with the currently valid standard

DIN 1986 / EN12056 and the local regulations.

• Before installation, the product must be checked for transport damage. No transport or

surface damage will be accepted after installation.

• The construction method of the bath may not be adjusted. Use only original parts.

• Only materials suited for the installation of a bathtub may be used!

• During assembly, gloves must be worn to prevent crushing and cutting wounds.

• No silicone containing acids may be used. The use of silicone containing acids may

damage the product.

• To fill the gaps between the elements, we recommend anti-fungal sanitary silicone. The

silicone may discolour after a while. If cleaning does not give sufficient results, the filling

must be replaced. This replacement is not covered by the warranty.