Instruction manual
5857
To Remove Cup Holder (drink-thingy
™
):
Step 1.
Remove Seat Cushion from Seat Base and set Seat Cushion to side. (See section titled
“Removing/Installing Seat Cushion & Seat Cushion Cover,” on page 58.)
Step 2.
Holding onto the outside of the Cup Holder, slide Cup Holder tabs out of slots in Seat Base.
Step 3.
Install Seat Cushion back onto Seat Base. (See section titled “Removing/Installing Seat
Cushion & Seat Cushion Cover,” on page 58.)
Instruction Manual Storage
After carefully reading and following these instructions, keep this manual for future use and
store in the compartment located on the bottom of the Seat Base, as shown in Figure 78.
Care & Cleaning
Removing/Installing Seat Cushion & Seat Cushion Cover
To Remove Seat Cushion Cover:
Step 1.
To remove Seat Cushion Cover, you must first remove the
entire Seat Cushion from the Seat Base.
Step 2.
Pull up on bottom front edge of Seat Cushion to release it
from the front of the Seat Base, as shown in Figure 79.
Step 3.
Pull the Seat Cushion forward to fully release it from the
Seat Base, as shown in Figure 80.
WARNING
t/&7&364-&34&"58*5)0654&"5$64)*0/*/1-"$&
Figure 79
Figure 78
Figure 80