Instruction manual

4443
Step 6.
Pull on shoulder belt to remove all slack out of the lap and
shoulder belt and snugly adjust the vehicle seat belt onto
the child.
IMPORTANT: Design and operation of vehicle seat belt
systems vary from vehicle to vehicle and from seating
location to seating location within the same vehicle. Refer
to your vehicle owner’s manual for proper use, placement
and adjustment of the vehicle’s lap and shoulder belts.
Step 7.
Check vehicle seat belt fit on the child:
t7FIJDMFTFBUCFMUT.645mUTOVHMZBOEMBZnBUBHBJOTU
the child and MUST not be loose or twisted. A snug seat
belt does not allow any slack. It lies in a relatively straight
line without sagging.
t5IFMBQCFMU.645TJUMPXBOETOVHMZPOUIFDIJMETIJQT
Pull on the shoulder belt to tighten.
t5IFTIPVMEFSCFMU.645CFBUPSBCPWFUIFDIJMET
shoulder, lie snugly across the mid point of the child’s
chest and across the center of the shoulder in the
GREEN zone, as shown in Figure 47.
If the shoulder belt is not positioned properly, adjust
the Headrest to change the shoulder belt position.
(See “Adjusting the Headrest” section of this manual
on page 46.)
Figure 47
IMPORTANT: If the shoulder belt is off the child’s shoulder, not centered on the child’s chest,
or the ears are above the top of the headrest in the highest adjustment position, then your
child is too large to use this booster seat in full back mode.
t%0/05QPTJUJPOBOZQBSUPGUIFWFIJDMFTFBUCFMUPWFSUIFUPQPGUIF"SNSFTUBTTIPXO
in Figure 48, behind the Armrest, as shown in Figure 49, under the child’s arm, as shown
in Figure 50, or behind the child, as shown in Figure 51.
Figure 50
Figure 49
Figure 51
Figure 48