Instruction manual

3635

Step 2.

Center this booster seat on the vehicle seat and position

this booster seat ﬁrmly against seat back with LATCH

Connectors tucked into the crease between the vehicle

seat back and vehicle seat cushion.

Step 3.

Ensure that the booster Seat Base is in contact with the

vehicle seat back, as shown in Figure 36.

DO NOT allow gap between the booster Seat Base

and vehicle seat back, as shown in Figure 37.

Figure 36

Figure 37

Installing Booster Seat in Backless Mode

WITHOUT Using LATCH Connectors

To remove Seat Back, see “Installing/Removing

Seat Back” section of this manual on page 53.

Step 1.

Select a forward-facing vehicle seating location, which has

a lap and shoulder belt.

If the vehicle seat back is adjustable, make sure the seat

back is locked in the upright position. DO NOT allow the

child to sit in this booster seat while the vehicle seat is

reclined, as shown in Figure 38.

Check that LATCH Connectors are fully retracted.

To fully retract LATCH Connectors, pull and hold Recline

Handle on front of booster seat and push LATCH

Connectors into Seat Base.

Figure 38