Instruction manual

3029
To connect to lower anchors, pull and hold Recline Handle on front of booster Seat Base
1
and pull LATCH Connectors out
2
, as shown in Figure 28.
Step 2.
Place this booster seat in the seating location selected with the LATCH Connectors facing
the vehicle seat.
Secure the LATCH Connectors to the vehicle LATCH lower anchors by aligning the LATCH
Connectors with the vehicle LATCH anchors and pressing the LATCH Connectors against
the LATCH lower anchors until you hear each LATCH Connector click, as shown in
Figure 29.
IMPORTANT: If LATCH Connectors fail to connect to the LATCH lower anchors, you can
still use this seat. See section titled “Installing Booster Seat in Backless Mode WITHOUT
Using LATCH Connectors” of this manual on page 36. However, please notify us if the
LATCH Connectors fail to latch by calling 1-866-656-2462.
Step 3.
Once the LATCH Connectors are securely connected to the LATCH lower anchors, pull
forward on this booster seat to make sure it is securely attached to the vehicle’s LATCH
lower anchors on both sides. If not, start over at Step 1.
Figure 29
1
2
Figure 28