Instruction manual

1817
Installing/Removing Booster Seat
Using LATCH Connectors
IMPORTANT: This booster seat is designed to be used with the vehicle’s LATCH
Anchorage System. Always secure this booster seat to the vehicle’s LATCH Anchorage
System, if available. If your vehicle does not have a LATCH Anchorage System, you can
still use this booster seat. See “Installing Booster Seat WITHOUT Using LATCH
Connectors” section of this manual on page 33.
WARNING
t'"*-63&501301&3-:*/45"--0364&5)*4#0045&34&"5*/$3&"4&45)&
3*4,0'4&3*064*/+63:03%&"5)505)&$)*-%"/%05)&34*/"4)"31
TURN, SUDDEN STOP OR CRASH.
t50"70*%*/+63:5)*4#0045&34&"5.645#&*/45"--&%#:"/"%6-5
t/&7&3-&"7&5)*4#0045&34&"56/4&$63&%*/:0637&)*$-&5)*4
BOOSTER SEAT MUST REMAIN CONNECTED TO THE LATCH LOWER
ANCHORS IN THE VEHICLE OR SECURED BY THE VEHICLE’S SEAT BELT EVEN
WHEN NOT IN USE. IN A SHARP TURN, CRASH OR SUDDEN STOP, AN
UNSECURED BOOSTER SEAT CAN BE THROWN AROUND AND COULD
SEVERELY INJURE VEHICLE OCCUPANTS.
Installing Booster Seat in Full Back Mode
When Using LATCH Connectors
To install Seat Back, see “Installing/Removing Seat Back”
section of this manual on page 53.
Step 1.
Select a forward-facing vehicle seating location which has
a lap and shoulder belt and LATCH Anchorage System.
If the vehicle seat back is adjustable, make sure the seat
back is locked in the upright position. DO NOT allow the
child to sit in this booster seat while the vehicle seat back
is reclined, as shown in Figure 11.
Locate the LATCH lower anchors (as explained in the
“Vehicle Child Restraint Anchorage System (LATCH)”
section of this manual and in your vehicle owner’s manual).
Figure 11