Instruction manual

83
84
Figure 119
TO REMOVE REAR-FACING ANTI-
REBOUND BAR
Step 1
Remove the Seat Cushion, see “Removing/
Installing Seat Cushion” on page 84.
If LATCH Push-on Connectors are stored,
remove them from their storage location, see
“Rear-Facing LATCH Storage” on page 88.
Step 2
Remove the Locking Pins and Locking Pin
Clips from the seat as shown in Figure 119.
The bar should slide down until it comes
completely out of the seat.
Step 3
Keep Locking Pins and Locking Pin Clips with
Anti-Rebound Bar for storage.
Step 4
Place LATCH Push-on Connectors back into
their storage location, see “Rear-Facing
LATCH Storage” on page 88.
Install the Seat Cushion, see “Removing/
Installing Seat Cushion” on page 84.
TO REMOVE SEAT CUSHION
Unfasten the locking tabs at the lower front
edge of the seat cushion.
Grasping Seat Cushion at the bottom front
edge, lift and pull forward as shown in
Figure 120. Once the Seat Cushion releases,
pull the Buckle through the Seat Cushion.
WARNING — DEATH or
SERIOUS INJURY can occur
• Never use this car seat without the Seat Cushion in place.
Removing/Installing Seat Cushion
Figure 120