Instruction manual

79
80
Shoulder Harness Cover
Removal/Installation
The Shoulder Harness Covers included with
this seat are optional.
Shoulder Harness Straps must be unthreaded
in order to remove (or install) the Shoulder
Harness Covers, and then rethreaded into
the proper Shoulder Harness Slots. See
“Shoulder Harness Adjustment” section on
pages 73–78 for instructions on how to
unthread and rethread the shoulder harness
straps.
Figure 111
Figure 112
Installing/Removing
Rear-Facing Base
TO INSTALL REAR-FACING BASE
Step 1
Place the car seat on a clean, stable surface
with the inside of the seat facing down.
Step 2
Line the Rear-Facing Base Retention Hooks
up with the openings in the bottom of the
car seat, as shown in Figure 113. Insert the
Rear-Facing Base Retention Hooks into the
openings and slide the base down until you
hear the Rear-Facing Base Release Lever
“click” to lock the base on as shown in
Figure 114.
Step 3
Pull up on Rear-Facing Base to check that it is
locked in place.
Figure 113
Figure 114