Instruction manual

51
52
Step 9
Once the LATCH Connectors are connected
to the LATCH lower anchors, check both
LATCH connector lock indicators located
behind the LATCH connectors to make sure
they have changed from red (unlocked) to
green (locked) as shown in Figure 53. Pull
forward on this car seat to make sure it is
securely attached to the vehicle’s LATCH
lower anchors on both sides. If not, go back
to Step 8. If LATCH cannot be successfully
connected in this seating position, it may be
necessary to try a different seating position,
go back to Step 2.
IMPORTANT: If LATCH Connectors fail
to connect to the vehicle’s LATCH lower
anchors, you can still use this seat. See
“Installing/Removing Car Seat Forward-
Facing: Using Vehicle Belt” on page 57.
Please notify Clek Customer Service if the
LATCH Connectors fail to latch by calling
1-866-656-2462.
Figure 53
2
1
Figure 54
Figure 55
Figure 56
Figure 55a
Step 10
Adjust seat to fit snugly against the vehicle
seat back as shown in Figure 54.
• Pull and hold Rigid LATCH Adjustment
Handle.
• Push car seat firmly into vehicle
seat back.
• Release Rigid LATCH Adjustment Handle.
If installing with LATCH and the vehicle belt:
• Pull free end lap belt only or shoulder
portion of lap/shoulder belt to remove
excess slack as shown in Figure 55 (lap
belt only) or Figure 55a (lap/shoulder
belt)
• If using a lap/shoulder belt: while
holding the vehicle belt tight, lock
Forward-Facing Belt Lock-off as shown
in Figure 56.
NOTE: Use only one Shoulder Belt
Lock-Off at a time. Never use both in the
Forward-Facing Mode.