Instruction manual

47
48
Step 4
Adjust car seat to the desired Forward-Facing
recline position by pulling Recline Handle out
and rotating car seat as shown in Figure 45.
NOTE: Recline positions 1 and 2 can be used
Forward-Facing. Recline position 1 CANNOT
be used Forward-Facing without a Top
Tether. Recline Position 3 can NEVER be used
Forward-Facing.
Step 5
Pull Rigid LATCH Lower Connectors to
the fully extended position as shown in
Figure 46.
• Pull and hold Rigid LATCH Adjustment
Handle.
• Grasp the back of the Rigid LATCH
Lower Connectors and pull out until
they stop.
• Release Rigid LATCH Adjustment
Handle.
Figure 45
Figure 47
Step 6
Remove Top Tether Hook from its storage
location on back of car seat. See “Top Tether
Storage” on page 90.
• Lengthen Top Tether belt by pressing
adjuster release button while pulling
strap as shown in Figure 47.
• Place Top Tether Hook in the seat of the
car seat.
Step 7
This car seat may be installed forward-
facing with both LATCH AND the vehicle
belt. This type of installation will allow the
LATCH lower anchors to be used until the
child reaches the maximum size requirements
of the seat.
IMPORTANT: NEVER install this car seat
using both LATCH and the vehicle belt if
prohibited in the vehicle’s owner’s manual
owner’s manual or if either of the conditions
shown in Figures 48 and 49 exist.
Figure 46
Figure 49
Seat belt is located
in between LATCH
anchors
Figure 48
Seat belt buckle is
located in between
LATCH anchors