Instruction manual

45
46
WARNING — DEATH or
SERIOUS INJURY can occur (continued)
• Do NOT install by this method for
a child weighing more than 35 lb
(15.9 kg).
• For children over 35 lb (15.9 kg),
LATCH and Vehicle Belt can be
used in combination up to 65 lb
(29.5 kg) in Forward-Facing
Mode only.
• NEVER use this car seat, when
installed with Rigid LATCH, while
the Yellow and Black Rigid LATCH
Label is visible, as shown in
Figure 42, unless the Top Tether
is attached as instructed in this
manual.
Step 1
If Rear-Facing Base or Anti-Rebound Bar is
attached, remove it now, see “Installing/
Removing Rear-Facing Base” on page 80
and “Installing/Removing Rear-Facing Anti-
Rebound Bar” on page 81.
Step 2
Select a Forward-Facing vehicle seating
location which has LATCH.
Locate the LATCH lower and top anchors
(as explained in the “Vehicle Child Restraint
Anchorage System (LATCH)” on page 17
in this manual and in your vehicle owner’s
manual). See Figure 43.
Step 3
If the vehicle seat back is adjustable, make
sure the seat back is locked in a more upright
position. Refer to vehicle owner’s manual for
recommended seat back angle. DO NOT
install or use this car seat while the vehicle
seat back is excessively reclined, as shown in
Figure 44.
Figure 43
Figure 44
LATCH
Lap/Shoulder
Belt & LATCH
Figure 42