Manualshelf

Instruction manual

ManualsBrandsClek ManualsAutomotiveFoonf
21222324252627282930
41
42
1
Forward-Facing
• Ground level must be within the recline
range designated for the age of the child.
Recline Range
1 year and up
All Rear-Facing Children
• To Adjust Rigid UAS Lower Connectors: Pull Rigid UAS Adjustment Handle and slide seat to desired position.
• To Release Rigid UAS Lower Connectors: Fully extend Connectors, then pull Rigid UAS Release Handles.
Figure 39
Step 10
Ground Level must be within the recline
range designated for the age of the child.
If an acceptable recline level cannot be
achieved using the vehicle seat back
adjustment, if vehicle owner’s manual allows
multiple positions, it may be necessary to
place a rolled towel or pool noodle under
the foot end of the car seat to achieve an
acceptable recline level.
Verify Ground Level is within the recline
range designated for the age of the child as
shown in Figure 39. If not, go back to Step
5, adjust the recline level and try installing
again, or move the seat to a different vehicle
seating position.
• IMPORTANT: If the seat is reclined too
much, the child could be ejected from
the car seat in a crash. If too upright,
infants could have difficulty breathing.
St ep 11
Install Seat Cushion, see “Removing/Installing
Seat Cushion” on page 84.
Removing Rear-Facing Car Seat Installed With Vehicle Belt
Figure 40
Step 1
Unbuckle vehicle belt.
• Pressing down in center of car seat to
reduce tension on vehicle belt will make
it easier to unbuckle vehicle belt as
shown in Figure 40.
Step 2
Remove Seat Cushion, see “Removing/
Installing Seat Cushion” on page 84.
Step 3
If used, open Rear-Facing Belt Lock-off as
shown in Figure 41.
Remove vehicle belt from Rear-Facing
Belt Path.
Step 4
Remove this car seat from vehicle.
Step 5
Install Seat Cushion, See “Removing/
Installing Seat Cushion” on page 84.
Figure 41
1
2