Instruction manual

37
38
1
2
Figure 30
Step 6
If installing with a lap/shoulder belt, open
one (1) Rear-Facing Belt Lock-off as shown
in Figure 30. You may use whichever Lock-off
provides the most secure installation.
NOTE: If your vehicle’s belt system is
equipped with an ELR/ALR Switchable
Locking Retractor (SLR), or if you are installing
with a lap belt, you may skip Step 6, and
install your car seat WITHOUT using a
Rear-Facing Belt Lock-off. Refer to the Child
Restraint section of your vehicle manual to
understand what type of belt system your
vehicle is equipped with.
Step 7
Route vehicle belt through the Rear-Facing
Belt Path and under the four Belt Tabs, as
shown in Figure 31a, and buckle vehicle belt,
as shown in Figure 31.
Check that Crotch Strap is not under the
vehicle belt as shown in Figure 31b.
Step 8
Choose the option that matches the type of
installation you are doing:
Option 1 — If installing with lap/shoulder
belt using a Rear-Facing Lock-off:
Tighten vehicle belt to secure the car seat.
• Press down in center of car seat to
depress the vehicle cushion and pull free
the shoulder portion of lap/shoulder belt
to tighten as shown in Figure 32.
• While holding the vehicle belt tight,
close Rear-Facing Belt Lock-off as shown
in Figure 33.
IMPORTANT: If Lock-off will not close easily,
it may be necessary to loosen the belt slightly
in order to properly position the belt under
the Belt Tabs and close the Lock-off.
Figure 31 Figure 31a
Figure 31b
Figure 32
Figure 33
2
1