Instruction manual

35
36
Installing Rear-Facing Car Seat With Vehicle Belt
WARNING — DEATH or
SERIOUS INJURY can occur
• Not all vehicle belts are safe for use with this car seat. Read the vehicle
belt requirements section in this manual and your vehicle owner’s manual.
• Vehicle belt must be routed through Rear-Facing Belt Path when car seat is
installed Rear-Facing.
Figure 28
Step 3
If the vehicle seat back is adjustable, make
sure the seat back is locked in a more upright
position. Refer to vehicle owner’s manual for
recommended seat back angle. DO NOT
install or use this car seat while the vehicle
seat back is excessively reclined, as shown in
Figure 28.
Step 4
Remove Seat Cushion, see “Removing/
Installing Seat Cushion” on page 84.
Step 5
Place car seat Rear-Facing in the vehicle seat
location selected with Rear-Facing Belt Path
toward vehicle seat back and centered in
seating position as shown in Figure 29.
Step 1
If Rear-Facing Base is not securely attached
to the seat, install it now, see “Installing/
Removing Rear-Facing Base” on page 80.
• Anti-Rebound Bar must be securely
attached to the car seat with the Locking
Pins, see “Installing/Removing Rear-
Facing Anti-Rebound Bar” on page 81.
Step 2
Select a Forward-Facing vehicle seating
location which has a vehicle belt which can
be used with this car seat.
Figure 29