Instruction manual

29
30
Step 4
Remove Seat Cushion, see “Removing/
Installing Seat Cushion” on page 84.
Remove Rear-Facing LATCH belt from its
storage location under the Seat Cushion, see
“Rear-Facing LATCH Storage” on page 88.
Lengthen each side of Rear-Facing LATCH
belt by pressing adjuster release button while
pulling belt to extend the length of lower
anchor belt as shown in Figure 18.
Step 5
Route the Rear-Facing LATCH Belt through the
Rear-Facing Belt Path, as shown in Figure 19.
Step 6
Center the Rear-Facing LATCH Belt in the Belt
Path and place it under the two forward Belt
Tabs and over Rear-Facing Belt Lock-offs as
shown in Figure 20.
Check that Crotch Strap is not under Rear-
Facing LATCH Belt as shown in Figure 20a.
Figure 19
Figure 18
Figure 20
Figure 20a
Step 7
Place car seat Rear-Facing in the vehicle
seat location selected with Rear-Facing Belt
Path toward vehicle seat back and centered
between the vehicle lower anchors as shown
in Figure 21.
Step 8
Secure Rear-Facing LATCH Push-on
Connectors to the vehicle LATCH lower
anchors. For each connector:
• Position red release button of Rear-
Facing LATCH Push-On Connector
facing away from car seat.
• Align LATCH Connector with the vehicle
LATCH anchor and press the LATCH
Connector against the LATCH anchor
until you hear the LATCH Connector
click, as shown in Figure 22.
• Pull on LATCH Connector to check that it
is securely locked on the vehicle LATCH
anchor.
Figure 21
Figure 22