Instruction manual

78
79
WARNING — DEATH or
SERIOUS INJURY can occur
• Never use this car seat without the Seat Cushion in place.
Operation and Adjustment
Removing/Installing Seat Cushion
TO REMOVE SEAT CUSHION
Unfasten the locking tabs at the lower front
edge of the seat cushion.
Grasping Seat Cushion at the bottom, front
edge, lift and pull forward as shown in
Figure 114. Once the Seat Cushion releases,
pull the Buckle through the Seat Cushion.
Figure 114
Figure 115
1
2
TO INSTALL SEAT CUSHION
Step 1
Insert the Buckle through the slot in the Seat
Cushion that matches the slot the Crotch
Strap is through in the seat.
Step 2
Insert the tabs on the back of the Seat
Cushion through the slots in the pad and into
the seat back at the back of the seat bottom.
Push the locking tabs at the lower front of the
Seat Cushion into the holes at the front edge
of the seat as shown in Figure 115.
Installing/Removing
Anti-Rebound Bar
TO INSTALL ANTI-REBOUND BAR
Step 1
Rotate Recline Foot to Rear-Facing position by
pulling on edge of Recline Foot and rotating
it forward until it locks in to position, as
shown in Figure 116.
Figure 116
lowered recline foot
Raised recline foot