Instruction manual

72
73
Step 1
Loosen Harness:
• While lifting up on Harness Adjuster
Tab, pull out on Shoulder Harness Straps
as shown in Figure 100.
NOTE: If the Harness cannot be adjusted
large enough, switch the Metal Harness Plate
to the lower sewn loops on Shoulder Harness
Straps. See “To Lengthen the Shoulder
Harness Webbing” on page 24.
Step 2
Place child in car seat with their back at
against the Seat Back as shown in Figure
101.
Step 3
Check position of Shoulder Harness.
• Rear-Facing - The Shoulder Harness
Straps must be through Shoulder
Harness Slots at or below and closest
to the child’s shoulders, as shown in
Figure 102.
Figure 102
Figure 100
Figure 101
• Forward-Facing - The Shoulder Harness
Straps must be through Shoulder
Harness Slots at or above and closest
to the child’s shoulders, as shown in
Figure 103.
If the child’s shoulders are above the
highest set of Shoulder Harness Slots in
the car seat’s seat back, your child is too
large for this car seat.
See “Shoulder Harness Adjustment” on page
20 to change position of Shoulder Harness
Straps.
Step 4
Check Position of Headrest:
• The bottom of the Headrest must always
be at or above the Harness Slots in use.
• Rear-Facing - The top of the child’s head
must be at least 1” (2.5 cm) below the
top of the car seat’s Headrest, as shown
in Figure 104. If the top of the child’s
head is less than 1” (2.5 cm) below
the top of the Headrest in the highest
adjustment position, your child is too
large for using this car seat Rear-Facing
and must be transitioned to Forward-
Facing use with this car seat.
Figure 104
Figure 103
1”