Instruction manual

68
69
Figure 94
Figure 95
Step 9
Attach Tether Hook to vehicle top tether
anchor as shown in Figure 94 or Figure 94a
and pull rmly on free end of strap until Top
Tether is snug.
Refer to vehicle owner’s manual for
recommended Top Tether routing and
identication of top tether anchor point
Step 10
Check for secure installation. Gripping car
seat at top of armrests, pull car seat front
to back and left to right to check for secure
installation as shown in Figure 95. Vehicle
belt and Top Tether must stay tight and child
restraint should not move more than 1” (2.5
cm) in any direction.
• If vehicle belt does not stay tight or
car seat cannot be securely installed,
try a different vehicle seating location
or install using LATCH, see “Installing
Forward-Facing Car Seat With LATCH”
on page 54.
Figure 94a
Step 1
Loosen Top Tether by pressing Tether Adjuster
release button while pulling strap as shown
in Figure 96.
Step 2
Remove Tether Hook from vehicle tether
anchor.
• Pull in and hold retention spring
on Tether Hook, then remove hook
from tether anchor as shown in
Figure 97 and 97a.
Step 3
Unbuckle vehicle belt.
• Pressing down in center of car seat to
reduce tension on vehicle belt will make
it easier to unbuckle vehicle belt as
shown in Figure 98.
Removing Forward-Facing Car Seat Installed With Vehicle Belt
Figure 96
Figure 97
Figure 97a
Figure 98
Figure 78