Instruction manual

58
59
Step 6
Route LATCH belt through the Forward-Facing
Belt Path as follows:
• Holding the LATCH lower connector
closest to the adjuster, route LATCH belt
through the Forward-Facing Belt Path
so that the LATCH belt passes through
both red Forward-Facing Belt Guides, as
shown in Figure 73.
• Check that the LATCH belt has no twists
in it, and that the red release buttons are
facing away from car seat, as shown in
Figure 73a.
Step 7
Check that the entire LATCH belt is laying
at, placed correctly through the Forward-
Facing Belt Guides, and NOT between the
Harness and seat, as shown in Figure 74.
Figure 73
Figure 73a
Figure 74
Step 8
Place car seat Forward-Facing in the vehicle
seating location selected, and connect
each LATCH lower connector to each
corresponding vehicle LATCH lower anchor.
For each connector:
• Press the LATCH Connector against the
LATCH lower anchor until you hear the
LATCH Connector click, as shown in
Figure 75.
• Pull on LATCH Connector to check that it
is securely locked on the vehicle LATCH
lower anchor.
IMPORTANT: Check that there are no twists
in the LATCH belt, and that LATCH belt is
contained in both red Forward-Facing Belt
Guides.
Step 9
Position car seat so it is touching the vehicle
seat back, and tighten LATCH belt to secure
it.
• Press down in center of car seat to
depress the vehicle seat cushion, and
pull on the end of the LATCH belt to
tighten as shown in Figure 76.
Figure 75
Figure 76