Instruction manual

56
57
Figure 69
Step 2
Select a Forward-Facing vehicle seating
location which has LATCH.
Locate the LATCH lower anchors and tether
anchor as shown in Figure 69. See “Vehicle
Child Restraint Anchorage System (LATCH)”
section on page 26 of this manual, and
check your vehicle owner’s manual for further
information.
Step 3
If the vehicle seat back is adjustable, make
sure the seat back is locked in a more upright
position. Refer to vehicle owner’s manual for
recommended seat back angle. DO NOT
install or use this car seat while the vehicle
seat back is excessively reclined, as shown in
Figure 70.
Figure 70
Step 4
Remove Top Tether Hook from its storage
location on back of car seat. See “Top Tether
Storage” on page 84.
• Lengthen Top Tether belt by pressing
adjuster release button while pulling
strap as shown in Figure 71.
• Place Top Tether Hook in the seat of the
car seat.
Step 5
If stored, remove LATCH lower connectors
from storage. See “LATCH Belt Storage” on
page 82.
• Pull LATCH Belt and Lower Connectors out
the right side of the Rear-Facing belt path,
as shown in Figure 72.
Figure 71
Figure 51
Figure X
Figure X
Figure 72