Instruction manual

54
55
Installing Forward-Facing Car Seat With LATCH
WARNING — DEATH or
SERIOUS INJURY can occur
• LATCH Belt must be routed through Forward-Facing Belt Path and be
contained in both red Forward-Facing Belt Guides when using this car
seat Forward-Facing.
• Only install this car seat using the LATCH system in vehicle seating
locations designated by the vehicle manufacturer for use with LATCH and
that have a standard anchor spacing of 11 in (280 mm).
• LATCH connectors must be secured to the vehicle LATCH lower anchors
only. Connection to other vehicle anchors or vehicle components could
result in the anchor tearing free in a crash.
• Never attach more than one LATCH connector to a vehicle lower anchor
unless recommended by the vehicle owner’s manual for that vehicle.
• ALWAYS secure the Top Tether provided with this car seat when installing
Forward-Facing using LATCH. NEVER use this car seat, when installing
Forward-Facing with LATCH, without the Top Tether.
Step 1
Check that the Recline Foot is in the Forward-
Facing position. If needed, grasp forward
edge of Recline Foot and rotate towards the
back of the seat, pressing it in to the recess in
the seat bottom, as shown in Figure 68.
– If the Anti-Rebound Bar is attached,
remove it now, see “Installing/Removing
Anti-Rebound Bar” on page 79.
Figure 68
lowered recline foot
Raised recline foot
WARNING — DEATH or
SERIOUS INJURY can occur (continued)
• Do NOT install by this method for a child
weighing more than 40 lb (18.1 kg).
LATCH