Instruction manual

50
51
Step 10
Check for secure installation. Gripping car
seat at top of armrests, pull car seat front
to back and left to right to check for secure
installation as shown in Figure 65. Vehicle
belt MUST stay tight and child restraint should
not move more than 1” (2.5 cm) in any
direction.
• If vehicle belt does not stay tight, try
installing the car seat using Rear-Facing
Belt Lock-off. Go back to Step 6.
• If vehicle belt still does not stay tight or
car seat cannot be securely installed,
try a different vehicle seat location or
install using the Anti-Rebound Bar (sold
separately), see “Installing Rear-Facing
Car Seat With LATCH” on page 35.
St ep 11
Verify that the Rear-Facing Level Reference
Line appropriate for the child’s weight is
parallel to the ground as shown in Figure 55
on page 46.
Step 12
Install Seat Cushion, see “Removing/Installing
Seat Cushion” on page 78.
Figure 65
Figure 67
Step 1
Unbuckle vehicle belt.
• Pressing down in center of car seat to
reduce tension on vehicle belt will make
it easier to unbuckle vehicle belt as
shown in Figure 66.
Step 2
Remove Seat Cushion, see “Removing/
Installing Seat Cushion” on page 78.
Step 3
If used, open Rear-Facing Belt Lock-off as
shown in Figure 67.
Remove vehicle belt from Rear-Facing
Belt Path.
Step 4
Remove this car seat from vehicle.
Step 5
Install Seat Cushion, See “Removing/
Installing Seat Cushion” on page 78.
Figure 66
Removing Rear-Facing Car Seat Installed With Vehicle Belt