Instruction manual

44
45
• If using the Anti-Rebound Bar, the
Anti-Rebound Bar must also be securely
attached to the seat, see “Installing/
Removing Anti-Rebound Bar” on page
79.
Step 2
Select a forward-facing vehicle seating
location which has a vehicle belt which can
be used with this car seat.
Step 3
If the vehicle seat back is adjustable, make
sure the seat back is locked in a more upright
position. Refer to vehicle owner’s manual for
recommended seat back angle. DO NOT
install or use this car seat while the vehicle
seat back is excessively reclined, as shown in
Figure 53.
Step 4
Remove Seat Cushion, see “Removing/
Installing Seat Cushion” on page 78.
Figure 53
Step 5
Place car seat Rear-Facing in the vehicle seat
location selected with Rear-Facing Belt Path
toward vehicle seat back and centered in
seating position as shown in Figure 54 with
Anti-Rebound Bar, or in Figure 54a without
Anti-Rebound Bar.
IMPORTANT: Car Seat base must NOT
extend beyond the edge of the vehicle seat
cushion as shown in Figure 54b.
Figure 54b
Figure 54
Figure 54a