Manualshelf

Instruction manual

ManualsBrandsClek ManualsAutomotiveFLLO
21222324252627282930
42
43
Figure 50
Figure 51
Removing Rear-Facing Car Seat Installed With LATCH
Step 1
Loosen LATCH Belt by pressing the adjuster
button on the LATCH Belt adjuster and pulling
out on LATCH Belt as shown in Figure 50.
• Pressing down in center of car seat to
reduce tension on LATCH Belt will make
it easier to loosen LATCH belt.
Step 2
Remove LATCH Push-on Connectors from
vehicle lower anchors.
• Press and hold red release button while
pulling LATCH push-on Connectors as
shown in Figure 51.
• Repeat to remove push-on connector on
opposite side.
Step 3
Remove this car seat from vehicle.
Step 4
Store the LATCH Belt, see “LATCH Belt
Storage” on page 82.
Installing Rear-Facing Car Seat With Vehicle Belt
WARNING — DEATH or
SERIOUS INJURY can occur
• Not all vehicle belts are safe for use with this car seat. Read your vehicle
owner’s manual and the “Vehicle Belt Requirements” section in this manual.
• Vehicle Belt must be routed through Rear-Facing Belt Path when car seat is
installed Rear-Facing.
Note: Use of the Anti-Rebound Bar with this
car seat is optional. In some vehicles it may
be easier to achieve a secure installation, at
the correct recline angle for your child either
with or without the Anti-Rebound Bar. The
installation process is the same with or without
the Anti-Rebound Bar.
Step 1
Rotate Recline Foot to Rear-Facing position by
pulling on edge of Recline Foot and rotating it
towards the front of the seat until it locks in to
position, as shown in Figure 52.
Figure 52