Instruction manual

40
41
• Pull on LATCH Connector to check that it
is securely locked on the vehicle LATCH
anchor.
Step 10
Tighten LATCH Belt to secure the car seat.
• Press down in center of car seat to
depress the vehicle seat cushion and pull
end of LATCH Belt to tighten as shown in
Figure 48.
St ep 11
Check for secure installation. Gripping car
seat at top of armrests, pull car seat front
to back and left to right to check for secure
installation as shown in Figure 49. LATCH
belt MUST stay tight and child restraint
should not move more than 1” (2.5 cm) in
any direction.
• If LATCH belt does not stay tight or
car seat cannot be securely installed,
try a different LATCH location or
install using the vehicle belt, see
“Installing Rear-Facing Car Seat With
Vehicle Belt” on page 43.
Figure 48
Figure 49
Step 12
Verify that the Rear-Facing Level Reference
Line appropriate for the child’s weight is
parallel to the ground as shown in Figure 46
on page 39.
Step 13
Install Seat Cushion, see “Removing/Installing
Seat Cushion” on page 78.