Instruction manual

24
25
Figure 24
Step 3
Attach desired loops at end of Shoulder
Harness Straps to Metal Harness Plate by
sliding strap into slot in plate as shown in
Figure 24.
TO LENGTHEN THE SHOULDER
HARNESS WEBBING
For larger children: to make the
Harness longer, attach the Metal
Harness Plate to the loop at the end of
the Shoulder Harness Strap as shown in
Figure 25.
IMPORTANT: Never use this harness
position when using with a child up to
40lb (18.1kg) and installing forward-
facing without a top tether.
TO SHORTEN THE SHOULDER HARNESS
WEBBING
For smaller children: to make the
Harness shorter, attach the Metal
Harness Plate to the loop further in from
the end of the Shoulder Harness Strap
as shown in Figure 26.
Figure 25
Figure 26
Figure 28
Check that both Shoulder Harness Straps are
attached to the Metal Harness Plate on the
same loop while ensuring that each Shoulder
Harness Strap is completely inside the slot in
metal Harness Plate as shown in Figure 27.
Step 4
Reattach Shoulder Harness Access Panel to
back of car seat:
• Insert the access panel and twist the
access panel lock clockwise as shown in
Figure 28.
Step 5
If installing this car seat rear-facing, store
the Top Tether. See “Top Tether Storage” on
page 84.
Figure 27