Instruction manual

22
23
Step 2
Remove Top Tether from storage. See “Top
Tether Storage” on page 84.
Step 3
Remove Shoulder Harness Access Panel from
back of car seat:
• Twist the access panel lock counter-
clockwise and pull to remove as shown
in Figure 20.
Step 4
Remove loops at ends of Shoulder Harness
Straps from Metal Harness Plate by sliding
strap out through slot in Metal Harness Plate
as shown in Figure 21.
Step 5
From front of car seat, pull Shoulder Harness
Straps out of seat back.
Figure 21
Figure 20
Figure 22
SHOULDER HARNESS RETHREADING
Step 1
Check that Harness Straps are not twisted
and from front of seat, insert Shoulder
Harness Straps through the chosen Shoulder
Harness Slots as shown in Figure 22. Straps
MUST go through the Shoulder Harness Slots
at the same height on each side
Step 2
Route Shoulder Harness under bottom of seat
back cover (1) as shown in Figure 23.
1
Figure 23